Blata Elite 14 - 4 Wartungshandbuch

7

8

MINIBIKE ELITE 14 - 4,2 180.000.00 MINIBIKE ELITE 14 - 4,2 330.083.00 AIR FILTER LI - 60 ENGINE 330.085.00 BEARING CASE 110.080.76 JET 7

10 184.004.00 SEAT-TAIL ASSEMBLY NON VARNISHED OTHER HARDWARE 184.006.00 FAIRING VARNISHED 911.002.01 SCREW M 8 x 45 184.007.00 SEAT-TAIL A

11

FIG. 16 12 159.019.00 MP - 1 FIG. 6

13 FIG. 7512.060.00

REMOVE AND REPLACE THE FRONT WHEEL - FIG. 5 Before dismantling the front wheel it is necessary to remove the front brake pads from the front brake,

REPLACEMENT OF TIRE – FIG. 5 Remove the wheel from the minibike. For the front wheel unbolt the brake disk and for the rear wheel, the brake disk an

TORQUE SETTINGS (1 FT-LB = 1.3558 Nm) PART NAME QTY TORQUE SETTING (FT-LB) SECURED BY ENGINE Cylinder head, liq

Noise emitted by machinery and equipment (Minibike BLATA ELITE 14) - Measurement of emission sound pressure levels

NON USE AND STORAGE PROCEDURE It is recommended to drain out all fuel from the tank and carburetor. Inflate the tires to the working pressure and

SAFETY WARNING Always pay attention to the instructions and safety warnings below This manual contains important safety information and ins

MINIBIKE – ELITE14 – 4,2 SERVICE MANUAL FOR USE AND MAINTENANCE AND SPARE PARTS LIST For your own safety and the safety of others Follow these rec

INTRODUCTION The Minibike Elite 14 – 4,2 is designed and built for use on a paved closed circuit track. The track should be clean and without obst

UNPACKING AND SETTING UP BEFORE RIDING The minibike is delivered in a cardboard carton and packed with folded handlebars and brake levers. After un

STARTING THE ENGINE Engine starting should be done only on the stand - Fig. 2. Fill the fuel tank and close it with the filler cap. Open the Gas pet

PERIODIC MAINTENANCE Periodic maintenance is the best way to help the machine perform well, give longevity and provide safety and low cost operation

ADJUSTING THE BRAKES Small incremental brake adjustment Free play at the handlebar lever is effected by turning the knurled end on the cable adjus